To Set The Channel Label - Rigol MSO4000 Series User Manual

Chapter 2 Vertical System Setting

To Set the Channel Label

By default, the oscilloscope uses the number of the channel (such as
at the left of the screen) to mark the corresponding analog channel. For easier use,
you can define a label for each analog channel.
The label modification interface is as shown in the figure below.
Name Input Area
Name Input Area: display the label characters currently input;
Keyboard: used to input the specified character;
Upper/Lower Case Switch: used to switch between English uppercase and
lowercase inputs. "
Note: The user-defined label can include uppercase English letters (from A to Z),
lowercase English letters (from a to z), numbers (from 0 to 9), underline and space;
the length of the label cannot exceed 4 characters.
For example, change the label of CH1 to "Chn1".
1.
2.
MSO4000/DS4000 User's Guide
800.544.2843
A
a" denotes lowercase and "
Press CH1 Label to open the lable submenu and the label modification
interface (as shown in the figure above).
If there are characters in the "Name Input Area", please press Delete
continuously to delete all the characters.
Input the first character "C".
1) If the system is in uppercase input ("
2). If the system is in lowercase input ("
Keyboard to select the "Keyboard" area, turn the multi-function knob
A
to select " a" and press the knob to switch to "
www.calcert.com
15
10 20
5 25
0 30
Keyboard Upper/Lower Case Switch
a
A" denotes uppercase.
a
A" is displayed), please move to step
A
a" is displayed), please press
, displayed
a
A".
sales@calcert.co
RIGOL
2-15