Rigol MSO4000 Series User Manual page 206

RIGOL
You can use cursor to perform manual measurement on the waveform of CH1 to CH4
or MATH channel following the steps below.
1. Turn on the manual measurement function
Press Cursor  Mode, turn the multi-function knob
press the knob. You can also press Cursor or Mode continuously to switch to
"Manual". At this point, the oscilloscope measures the values at the cursors of
the specified source channel waveform and displays the measurement results at
the upper-left side of the screen. When the cursor measurement parameters are
modified, the measurement result will change accordingly.
2. Specify the measurement source
Press Source and turn the multi-function knob
MATH. You can also press Source continuously to switch the current source. If
"None" is selected, no cursor and measurement result will be displayed.
Note: Only channels currently turned on can be selected.
3. Specify the display mode
Press DisplayMode and turn the multi-function knob to
cursor display mode. You can also press DisplayMode continuously to switch
the current cursor display mode.
X: only display the X cursors (a pair of vertical solid/dotted lines).

―
―
Y: only display the Y cursors (a pair of horizontal solid/dotted lines).

―
―
X-Y: display the X cursors (a pair of vertical solid/dotted lines) and Y cursors

(a pair of horizontal solid/dotted lines) at the same time.
6-40
800.544.2843
You can select to measure the time (s), frequency (Hz), phase (°) or
ratio (%) using the X cursors by setting the "horizontal
The measurement results include A->X, B->X, △X and 1/△X (only
measurement unit" (Time Unit).
displayed when Time Unit is set to "s" or "Hz").
You can select to measure the amplitude (the unit is tha same as that
of the source channel amplitude) or ratio (%) using the Y cursors by
The measurement results include A->Y, B->Y and △Y.
setting the "vertical measurement unit" (Vertical Unit).
www.calcert.com
15
10 20
5 25
0 30
Chapter 6 Operations and Measurements
to select "Manual" and
to select CH1 to CH4 or
select the desired
MSO4000/DS4000 User's Guide
sales@calcert.co