Rigol MSO4000 Series User Manual page 266

RIGOL
Press Event Table to turn on or off the event table. When the event table is
1)
turned on, the interface is as shown in Figure 8-7.
Line Number
Event Table
Serial Bus
The event table displays the detailed decoding information (include the
decoded data as well as the corresponding line number, time, message ID,
header CRC (HCRC), tail CRC (TCRC) and error information) of the
waveform on the screen in time order. At most 10 lines of decoding
information can be displayed on one page (the line number starts from 0).
You can turn the multi-function knob
view the corresponding decoding information. The line currently selected is
highlighted with brown shading and the decoded data of that line is
dispalyed at the lower-left side of the event table.
Note:



8-34
800.544.2843
Message ID Payload Length
Time Frame ID
Figure 8-7 FlexRay Decoding
The display format of the decoded data in the event table is determined
by the bus display format currently selected (refer to "Format").
When adjusting the horizontal time base, the waveform displayed on
the screen will change and the total number of lines of decoding
information in the event table will change.
The decoded data information displayed in the bus is related to the
www.calcert.com
15
10 20
5 25
0 30
Chapter 8 Protocol Decoding
Number of Cycles
Header CRC
Decoded Data
to select the specified line and
MSO4000/DS4000 User's Guide
Tail CRC
Dynamic Tail Sequence
sales@calcert.co