To Adjust The Horizontal Position - Rigol MSO4000 Series User Manual

Chapter 3 Horizontal System Setting

To Adjust the Horizontal Position

The horizontal position (also called trigger position) refers to the position of the
trigger point of the waveform relative to the screen center in the horizontal direction.
The horizontal position is positive (negative) when the waveform trigger point is at
the left (right) of the screen center.
Turning HORIZONTAL
channel waveform.


When modifying the horizontal position, the trigger point and the waveforms
displayed move left or right; the horizontal position information (as shown in the
figure below) at the upper-right side of the screen changes accordingly.
Note: When delayed sweep is turned on, HORIZONTAL
adjust the delayed sweep horizontal position (pressing this knob can quickly reset
the delayed sweep horizontal position); the delayed sweep horizontal position
information (as shown in the figure above) at the upper-right side of the screen
changes accordingly.
MSO4000/DS4000 User's Guide
800.544.2843
Turn the knob clockwise to reduce the horizontal position and counterclockwise
to increase the horizontal position.
Pressing the knob can quickly reset the horizontal position to 0.
www.calcert.com
15
10 20
5 25
0 30
POSITION can adjust the horizontal position of the
RIGOL
POSITION is used to
3-3
sales@calcert.co