To Turn The Reference Waveform Channel On/Off - Rigol MSO4000 Series User Manual

RIGOL

To Turn the Reference Waveform Channel On/Off

1. Enable the reference waveform function
Press REF in the vertical control area (VERTICAL) at the front panel to enable
the REF function and open the REF menu. The backlight of the key turns on
denoting that the reference waveform function is enabled. By default, only Ref1
channel is turned on.
Note: When the horizontal time base mode is X-Y, the reference waveform
function can not be enabled.
2. Turn the specified reference waveform channel on or off
In the REF menu, Press Channel and turn the multi-function knob
the specified reference waveform channel (Ref1 to Ref10); press the knob or
press Channel to turn the reference waveform channel on or off. When the
channel is turned on,
channel name; when the channel is turned off,
Note: You can turn on a single reference waveform channel or multiple
reference waveform channels at the same time according to your need.
For the reference waveform channel that is turned on, the corresponding channel
icon (for example,
reference waveform color, select the the reference waveform source channel, adjust
the vertical scale and vertical position of the reference waveform and save the
reference waveform to internal or external memory as well as recall it when needed.
For details, please refer to the introductions below.
9-2
800.544.2843
is displayed at the front of the reference waveform
) is displayed at the left of the screen grid. You can also set the
www.calcert.com
15
10 20
5 25
0 30
Chapter 9 Reference Waveform
to select
is displayed.
MSO4000/DS4000 User's Guide
sales@calcert.co