To Make One-Key Measurement - Rigol MSO4000 Series User Manual

RIGOL

To Make One-key Measurement

MSO4000/DS4000 provides the one-key measurement function through which you
can measure the 29 kinds of waveform parameters as shown in the table below.
Please turn on the channel to be measured before making measurement.
Table 6-5 29 Waveform Parameters
Parameter Type
Time Parameter
Delay and Phase
Parameters
Voltage Parameter
Area Parameter
You can perform one-key measurement following the steps below.
1. Specify the measurement source
The measurement source selection methods are different for different waveform
parameters.
Time, voltage and area parameter measurements

Press Measure  Source, turn the multi-function knob
channel to be measured and press the knob. You can also press Source
continuously to switch the current measurement source. The channels
available are CH1 to CH4, MATH and D0 to D15.
Note:
―
―
6-22
800.544.2843
Parameter Name
Period, Freq, Rise Time, Fall Time, + Width, -Width,
+Duty, -Duty (please refer to "Time Parameters")
Dly A →B , Dly A →B , Dly A →B , Dly A →B ,
Phs A →B , Phs A →B , Phs A →B , Phs A →B
(please refer to "Delay and Phase Parameters")
Vmax, Vmin, Vpp, Vtop, Vbase, Vamp, Vavg, Vrms-N,
Vrms-1, Overshoot, Preshoot (please refer to "Voltage
Parameters")
Area, Per.Area (please refer to "Area Parameters")
When the current measurement source is CH1 to CH4 or MATH, you
can switch the measurement source by switching the current active
channel (press CH1 to CH4 or MATH at the front panel).
When the current measurement source is D0 to D15, you can switch
www.calcert.com
15
10 20
5 25
0 30
Chapter 6 Operations and Measurements
MSO4000/DS4000 User's Guide
to select the
sales@calcert.co