Rigol MSO4000 Series User Manual page 137

Chapter 5 Trigger
3. Specify the slope condition
MSO4000/DS4000 User's Guide
800.544.2843
The calculation formula of the slope is:
Wherein, Time is the time setting value.
― When the slope condition is
slope range information is as shown in the figure below.
The calculation formula of the slope range is:
SlewRate =
Wherein,
UpperLimit
time lower limit.
Press When, turn the multi-function knob
condition and press the knob.You can also press When continuously to switch
the current slope condition. The slope type currently selected is displayed at the
upper-right side of the screen.
: trigger when the positive slope time of the input signal is greater

than the specified time setting.
: trigger when the positive slope time of the input signal is lower

than the specified time setting.
: trigger when the positive slope time of the input signal is greater

than the specified lower limit of time and lower than the specified upper
limit of time.
: trigger when the negative slope time of the input signal is greater

than the specified time setting.
: trigger when the negative slope time of the input signal is lower

than the specified time setting.
: trigger when the negative slope time of the input signal is greater

www.calcert.com
15
10 20
5 25
0 30
UpLevel - LowLevel
SlewRate =
Time
or
UpLevel - LowLevel UpLevel - LowLevel
~
UpperLimit
is the time upper limit and LowerLimit is the
to select the desired slope
RIGOL
, the trigger level and
LowerLimit
sales@calcert.co
5-25