To Set The Template (Trace Mode) - Rigol MSO4000 Series User Manual

Chapter 11 Waveform Recording
After waveform is recorded, press Record  Mode; turn the multi-function knob
to select "Analyze" and press the knob. At this point, the screen is divided into
two display areas as shown in the figure below.
Settings and Results
In the waveform recording menu (Mode is set to "Analyze"), you can set the related
parameters of waveform analysis, execute the analysis operation and view the
analysis results according to the instructions below.
 Spesify the analysis mode and set the template or test mask
 Specify the source of waveform analysis
 Set the waveform analysis range, number of frames and threshold
 Start the analysis
 View the analysis results
1. Spesify the analysis mode and set the template or test mask
MSO4000/DS4000 User's Guide
800.544.2843
Templet Display
Press Analyze to select "Trace" or "Pass/Fail".
Trace: perform analysis on the basis of the template set by users.

After selecting this mode, please set the desired template by referring to

"To Set the Template (Trace Mode)".

www.calcert.com
15
10 20
5 25
0 30
Current Frame
RIGOL
11-13
sales@calcert.co