To Specify The Measurement Range - Rigol MSO4000 Series User Manual

Chapter 6 Operations and Measurements

To Specify the Measurement Range

Press Measure  Range to open the measurement range setting menu. In this
menu, press Range to set the measurement range of one-key measurement to
"Screen" or "Cursor".
When "Cursor" is selected, two cursor lines (as shown in the figure below) appear on
the screen. You can determine the measurement range by adjusting the positions of
cursor A and cursor B. Press CursorA and CursorB and turn the multi-function knob
to adjust the positions of cursor A and cursor B respectively. Or press CursorAB
and turn the multi-function knob
same time (the disatnce between the two cursors remains unchanged).
Note: When the measurement range setting menu is opened, pressing the
multi-function knob
and CursorAB.
MSO4000/DS4000 User's Guide
800.544.2843
to adjust the positions of cursors A and B at the
continuously can quickly switch among CursorA, CursorB
www.calcert.com
15
10 20
5 25
0 30
RIGOL
6-31
sales@calcert.co