Rigol MSO4000 Series User Manual page 40

RIGOL
To Connect the Active Probe
Take RP7150 (with differential probe front) as an example.
1. Connect the probe front with the active probe amplifier.
2. Connect the other end of the active probe amplifier to the analog channel input
terminal or external trigger input connector of the oscilloscope at the front panel
(please refer to "Front Panel Overview"). Note that you need to push the
probe to the due position to lock it firmly.
3. Connect the probe front to the circuit under test using the probe auxiliary
equipment.
After connecting the active probe, you can perform probe calibration and offset
voltage adjustment. For the detailed steps, refer to "Active Probe".
1-10
800.544.2843
Figure 1-7 To Connect the Active Probe
www.calcert.com
15
10 20
5 25
0 30
Chapter 1 Quick Start
MSO4000/DS4000 User's Guide
sales@calcert.co