To Perform Internal Storage And Recall - Rigol MSO4000 Series User Manual

Chapter 13 Store and Recall

To Perform Internal Storage and Recall

The internal memory supports the storage and recall of setup files, reference
waveform files and pass/fail test mask files. In the following section, the internal
storage and recall method and procedures are introduced by taking the setup file as
an example.
1. Save the specified oscilloscope setting in internal memory
MSO4000/DS4000 User's Guide
800.544.2843
1) Connect the signal to the oscilloscope and set the related parameters to
obtain stable display.
2) Press Storage  Storage; turn the multi-function knob
"Setups" and press the knob. You can also press Storage continuously to
switch to "Setups".
3) Press Save to turn on the disk management interface. Turn the
multi-function knob
and press down the knob to open the local disk storage interface (as shwon
in Figure 13-1).
4) The local disk can store at most 10 setup files. Turn the multi-function knob
to select the desired storage location and Save becomes available; then
press the softkey to execute the saving operation. If the current location
contains a file, you can press Save  OK to directly overwrite the original
file or press Delete to delete the file.
www.calcert.com
15
10 20
5 25
0 30
to select "Local Disk" (the characters turn green)
Figure 13-1 Local Disk (Storage)
RIGOL
to select
13-5
sales@calcert.co