Danfoss VLT Flow Drive FC 111 Programming Manual page 47

VLT® Flow Drive FC 111
Programming Guide
[28]
[29]
[30]
[31]
[32]
1-22 Motor Voltage
Default value: Configuration dependent
Conversion index: -
Enter the nominal motor voltage according to the motor nameplate data. The default value corresponds to the nominal rated out-
put of the unit.
Table 48: Range:
Min: 50 V Max: 1000 V
1-23 Motor Frequency
Default value: Configuration dependent
Conversion index: -
Select the motor frequency value from the motor nameplate data.
Table 49: Range:
Min: 20 Hz Max: 400 Hz
1-24 Motor Current
Default value: Configuration dependent
Conversion index: -2
Enter the nominal motor current value from the motor nameplate data. This data is used for calculating motor torque, motor ther-
mal protection, and so on.
Table 50: Range:
Min: 0.01 A Max: 1000.00 A
1-25 Motor Nominal Speed
Default value: Configuration dependent
Conversion index: -
Enter the nominal motor speed value from the motor nameplate data. This data is used for calculating automatic motor compensa-
tions.
Table 51: Range:
Min: 50 RPM Max: 60000 RPM
1-26 Motor Cont. Rated Torque
Default value: Configuration dependent
Conversion index: -1
Danfoss A/S © 2021.07
160 kW - 215 hp
200 kW - 270 hp
250 kW - 340 hp
315 kW - 425 hp
355 kW - 480 hp
Parameter type: Range
Data type: u_int16
Default value: Configuration dependent
Parameter type: Range
Data type: u_int16
Default value: Configuration dependent
Parameter type: Range
Data type: u_int32
Default value: Configuration dependent
Parameter type: Range
Data type: u_int16
Default value: Configuration dependent
Parameter type: Range
Data type: u_int16
2-setup: All setups
Change during operation: False
2-setup: All setups
Change during operation: False
2-setup: All setups
Change during operation: False
2-setup: All setups
Change during operation: False
2-setup: All setups
Change during operation: False
AU363928304090en-000101 / 130R0982 | 47
Parameters