Danfoss VLT Flow Drive FC 111 Programming Manual page 105

VLT® Flow Drive FC 111
Programming Guide
4.9.2 8-3* FC Port Settings
8-30 Protocol
Default value: [0] FC
Conversion index: -
Select the protocol for the integrated RS485 port.
Table 187: Option:
[0] FC
[2] Modbus RTU
[3] Metasys N2
[4] FLN
[5] BACnet
[20] LEN
[24] Vertiv MB Con-
verter
8-31 Address
Default value: Configuration dependent
Conversion index: -
Enter the address for the RS485 port. Valid range: 1–126 for FC-bus OR 1– 247 for Modbus.
Table 188: Range:
Min: 0.0 Max: 247
8-32 Baud Rate
Default value: -
Conversion index: -
Select the baud rate for the RS485 port. Default value refers to the FC protocol. Changing the protocol in parameter 8-30 Protocol
may change the baud rate.
Table 189: Option:
[0] 2400 Baud
[1] 4800 Baud
[2] 9600 Baud
[3] 19200 Baud
[4] 38400 Baud
Danfoss A/S © 2021.07
Parameter type: Option
Data type: u_int8
Communication according to the FC Protocol.
Communication according to the Modbus RTU protocol.
Communication protocol. The N2 software protocol is designed to be general in nature to accommo-
date the unique properties each device may have.
Communication according to the FLN protocol.
Communication according to the BACNet protocol.
Communication according to the LEN protocol.
Communication according to the Vertiv MB Converter protocol.
Parameter type: Range
Data type: u_int8
Default value: Configuration dependent
Parameter type: Option
Data type: u_int8
–
Default setting for FLN.
Default setting for:
• BACnet.
• Metasys N2.
Default setting for Modbus RTU.
–
2-setup: 1 setup
Change during operation: True
2-setup: 1 setup
Change during operation: True
2-setup: 1 setup
Change during operation: True
AU363928304090en-000101 / 130R0982 | 105
Parameters