Parameter Group 30-** Special Features - Danfoss VLT Flow Drive FC 111 Programming Manual

VLT® Flow Drive FC 111
Programming Guide
25-81 Pump Status
Default value: 0
Conversion index: 0
View the status for the pumps connected.
• X=Disabled
• O=Off
• D=Speed controlled
• R=Mains
Table 463: Range:
Min: 0
25-82 Lead Pump
Default value: 0
Conversion index: 0
View which pump is speed-controlled by the drive.
Table 464: Range:
Min: 0
25-84 Pump ON Time
Default value: 0 h
Conversion index: 0
View the total operating hours of the connected pumps. This parameter can be reset to 0.
Table 465: Range:
Min: 0 h Max: 2147483647 h
4.19.6 25-9* Service
Parameters for service use.
25-90 Pump Interlock
Default value: [0] Off
Conversion index: -
Choose the pump to interlock for, for example, service. The pump will be taken out of any pump cycling, and more.
Table 466: Option:
[0]
[1]

4.20 Parameter Group 30-** Special Features

4.20.1 30-2* Adv. Start Adjust
Parameter group for advanced start adjustments.
Danfoss A/S © 2021.07
Parameter type: Range
Data type: VisibleString
Max: 25
Parameter type: Range
Data type: u_int8
Max: 5
Parameter type: Range
Data type: u_int32
Parameter type: Option
Data type: u_int8
2-setup: All setups
Change during operation: True
Default value: 0
2-setup: All setups
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0 h
2-setup: All setups
Change during operation: True
Off
On
AU363928304090en-000101 / 130R0982 | 189
Parameters