Danfoss VLT Flow Drive FC 111 Programming Manual page 134

VLT® Flow Drive FC 111
Programming Guide
14-28 Production Settings
Default value: [0] No action
Conversion index: -
Service use only.
Table 247: Option:
[0]
[1]
[3]
14-29 Service Code
Default value: 0
Conversion index: 0
Service use only.
Table 248: Range:
Min: 0 Max: 2147483647
4.11.4 14-3* Current Limit Ctrl.
Parameters for configuring the current limit controller, which is activated when the motor current exceeds the preset current limits
(see parameter 4-18 Current Limit). These parameters are used to reduce torque as quickly as possible without losing control of the
motor.
14-30 Current Lim Ctrl, Proportional Gain
Default value: 100%
Conversion index: 0
Enter the proportional gain value for the current limit controller. A higher value makes the controller react faster. Excessive value
setting leads to controller instability.
Table 249: Range:
Min: 0%
14-31 Current Lim Ctrl, Integration Time
Default value: 0.020 s
Conversion index: -3
Control the current limit control integration time. Setting it to a lower value makes it react faster. A setting too low leads to control
instability.
Table 250: Range:
Min: 0.002 s
14-32 Current Lim Ctrl, Filter Time
Default value: 26.0 ms
Conversion index: -1
134 | Danfoss A/S © 2021.07
Parameter type: Option
Data type: u_int8
No action
Service reset
Software Reset
Parameter type: Range
Data type: u_int32
Parameter type: Range
Data type: u_int16
Max: 500%
Parameter type: Range
Data type: u_int16
Max: 2 s
Parameter type: Range
Data type: u_int16
2-setup: 1 setup
Change during operation: False
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: All setups
Change during operation: True
Default value: 100%
2-setup: All setups
Change during operation: True
Default value: 0.020 s
2-setup: All setups
Change during operation: True
AU363928304090en-000101 / 130R0982
Parameters