Danfoss VLT Flow Drive FC 111 Programming Manual page 154

VLT® Flow Drive FC 111
Programming Guide
16-73 Counter B
Default value: 0
Conversion index: 0
View the present value of counter B. Counters are useful as comparator operands, see parameter 13-10 Comparator Operand. The
value can be reset or changed either via digital inputs (parameter group 5-1* Digital Inputs) or by using an SLC action (parameter
13-52 SL Controller Action).
Table 338: Range:
Min: -32768
16-79 Analog output 45 [mA]
Default value: 0 mA
Conversion index: -2
View the actual value at output 45 in mA. The value shown reflects the selection in parameter 6-70 Terminal 45 Mode and parameter
6-71 Terminal 45 Analog Output.
Table 339: Range:
Min: 0 mA
4.13.6 16-8* Fieldbus & FC Port
Parameters for reporting the bus references and control words.
16-86 FC Port REF 1
Default value: 0
Conversion index: 0
View the last received reference from the FC port.
Table 340: Range:
Min: -32768
4.13.7 16-9* Diagnosis Read-Outs
16-90 Alarm Word
Default value: 0
Conversion index: 0
View the alarm word sent via the serial communication port in hex code.
Table 341: Range:
Min: 0 Max: 4294967295
16-91 Alarm Word 2
Default value: 0
Conversion index: 0
View the alarm word 2 sent via the serial communication port in hex code.
Table 342: Range:
Min: 0 Max: 4294967295
154 | Danfoss A/S © 2021.07
Parameter type: Range
Data type: int16
Max: 32767
Parameter type: Range
Data type: u_int16
Max: 20 mA
Parameter type: Range
Data type: int16
Max: 32767
Parameter type: Range
Data type: u_int32
Parameter type: Range
Data type: u_int32
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0 mA
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0
AU363928304090en-000101 / 130R0982
Parameters