Table of Contents
Advertisement
VLT® Flow Drive FC 111
Programming Guide
[61]
Counter A
Input for decrement counting in the SLC counter.
(down)
[62]
Reset Counter
Input for reset of counter A.
A
[63]
Counter B (up)
Input for increment counting in the SLC counter.
[64]
Counter B
Input for decrement counting in the SLC counter.
(down)
[65]
Reset Counter B
Input for reset of counter B.
[101]
Sleep
A signal applied puts the drive into sleep mode.
[120]
Lead Pump
A signal applied puts the lead pump into start mode.
Start
[121]
Lead Pump Al-
A signal applied puts the lead pump into alternation mode.
ternation
[130]
Pump 1 Inter-
A signal applied puts pump 1 into interlock mode.
lock
[131]
Pump 2 Inter-
A signal applied puts pump 2 into interlock mode.
lock
[132]
Pump 3 Inter-
A signal applied puts pump 3 into interlock mode.
lock
[133]
Pump 4 Inter-
A signal applied puts pump 4 into interlock mode.
lock
[134]
Pump 5 Inter-
A signal applied puts pump 5 into interlock mode.
lock
[190]
Fire Mode Ref
Enable a selection of 1 of the 8 fire mode references according to
Bit 0
[191]
Fire Mode Ref
Enable a selection of 1 of the 8 fire mode references according to
Bit 1
[192]
Fire Mode Ref
Enable a selection of 1 of the 8 fire mode references according to
Bit 2
4.7.3 5-3* Digital Outputs
Parameters for configuring the output functions for the output terminals.
5-30 Terminal 27 Digital Output
Default value: [0] No operation
Conversion index: -
Select the function for terminal 27 digital output.
Table 138: Option:
[0]
No operation
[1]
Control Ready
[2]
Drive ready
Danfoss A/S © 2021.07
Parameter type: Option
Data type: u_int8
No operation.
The control board receives supply voltage.
The drive is ready for operation and applies a supply signal on the control board.
Table
133.
Table
133.
Table
133.
2-setup: All setups
Change during operation: True
AU363928304090en-000101 / 130R0982 | 79
Parameters
Advertisement
Table of Contents
