Danfoss VLT Flow Drive FC 111 Programming Manual page 176

VLT® Flow Drive FC 111
Programming Guide
22-82 Work Point Calculation
Default value: [0] Disabled
Conversion index: -
Table 412: Option:
[0] Disabled
[1] Enabled
22-84 Speed at No-Flow [Hz]
Default value: Configuration dependent
Conversion index: -1
Set the motor speed in Hz at which flow is 0 and minimum pressure is achieved.
Table 413: Range:
Min: 0 Hz Max: 400.0 Hz
22-86 Speed at Design Point [Hz]
Default value: Configuration dependent
Conversion index: -1
Set the motor speed in Hz at which system design working point is achieved.
Table 414: Range:
Min: 0 Hz Max: 400.0 Hz
22-87 Pressure at No-Flow Speed
Default value: 0
Conversion index: -3
Set the pressure value corresponding to speed at no flow.
Table 415: Range:
Min: 0 Max: 4999.000
22-88 Pressure at Rated Speed
Default value: 4999.000
Conversion index: -3
Set the pressure value corresponding to pressure at rated speed.
Table 416: Range:
Min: 0 Max: 4999.000
22-89 Flow at Design Point
Default value: 0
Conversion index: -3
Set the flow value corresponding to flow at design point.
176 | Danfoss A/S © 2021.07
Parameter type: Option
Data type: u_int8
Disable calculation of working point at rated speed.
Enable calculation of working point at rated speed.
Parameter type: Range
Data type: u_int16
Default value: Configuration dependent
Parameter type: Range
Data type: u_int16
Default value: Configuration dependent
Parameter type: Range
Data type: u_int32
Parameter type: Range
Data type: u_int32
Parameter type: Range
Data type: int32
2-setup: All setups
Change during operation: True
2-setup: All setups
Change during operation: True
2-setup: All setups
Change during operation: True
2-setup: All setups
Change during operation: True
Default value: 0
2-setup: All setups
Change during operation: True
Default value: 4999.000
2-setup: All setups
Change during operation: True
Parameters
AU363928304090en-000101 / 130R0982