Danfoss VLT Flow Drive FC 111 Programming Manual page 58

VLT® Flow Drive FC 111
Programming Guide
Set the duration of the DC-brake current set in parameter 2-01 DC Brake Current, once activated.
Table 89: Range:
Min: 0 s
2-04 DC Brake Cut In Speed
Default value: 0 Hz
Conversion index: -1
This parameter is for setting the DC-brake cut-in speed at which parameter 2-01 DC Brake Current is to be active with a stop com-
mand.
Table 90: Range:
Min: 0 Hz
2-06 Parking Current
Default value: 100%
Conversion index: -
Set current as percentage of rated motor current, parameter 1-24 Motor Current. Active with parameter 1-73 Flying Start. The parking
current is active during the time period set in parameter 2-07 Parking Time.
Parameter 2-06 Parking Current is only active when 1 of the PM motor construction options is selected in parameter 1-10 Motor
Construction.
Table 91: Range:
Min: 0%
2-07 Parking Time
Default value: 3 s
Conversion index: -1
Set the duration of the parking current time set in parameter 2-06 Parking Current. Active with parameter 1-73 Flying Start.
Parameter 2-07 Parking Time is only active when options of parameter 1-10 Motor Construction are set to enable PM motors.
Table 92: Range:
Min: 0.1 s
4.4.2 2-1* Brake Energy Function
Parameter group for selecting dynamic brake parameters.
2-10 Brake Function
Default value: [0] Off
Conversion index: -
58 | Danfoss A/S © 2021.07
Max: 60 s
Parameter type: Range
Data type: u_int16
Max: 500 Hz
Parameter type: Range
Data type: u_int16
N O T I C E
Max: 150%
Parameter type: Range
Data type: u_int16
N O T I C E
Max: 60 s
Parameter type: Option
Data type: u_int8
Default value: 10 s
2-setup: All setups
Change during operation: True
Default value: 0 Hz
2-setup: All setups
Change during operation: True
Default value: 100%
2-setup: All setups
Change during operation: True
Default value: 3 s
2-setup: All setups
Change during operation: True
AU363928304090en-000101 / 130R0982
Parameters