Driving On Lifts - Still RX20 Series Original Instructions Manual

Operation
It is not permitted to drive on long ascending
and descending gradients greater than 15%
due to the specified minimum braking and
stability values.
– Before driving on ascending and descend-
ing gradients greater than 15%, consult the
authorised service centre.
The process of placing loads into stock
and removing loads from stock while on
an ascending or descending gradient is not
permitted!
– Always place loads into stock and remove
loads from stock on a horizontal plane.

Driving on lifts

The driver may only use this truck on lifts
with a sufficient load capacity and for which
the operating company has been granted
authorisation (refer to the section entitled
"Definition of responsible persons").
DANGER
There is a risk of fatal injury from being crushed or
run over by the truck.
– There must not be any persons already in the lift
when the truck is driven into the lift.
– Persons are only permitted to enter the lift once
the truck is secure, and must exit the lift before
the truck is driven out.
56368011531 EN - 06/2019 - 02
4
Handling loads
205