Switching On Via Push Button (Variant) - Still RX20 Series Original Instructions Manual

4
Switching on
Switching on via push button
(variant)
WARNING
All checks and tasks required before daily use must
have been performed without any defects being
identified before switching on the truck.
– Perform the "visual inspections and functional
checks".
– Do not operate the truck if defects have been
detected; contact the authorised service centre.
The "Switch on via push button" variant
is available only in conjunction with the
"FleetManager" or "Access authorisation with
PIN code" variants. In place of the key switch,
the truck has a push button (1) that is used to
switch the truck on and off.
– To switch on the truck, press the push
button (1) or sit on the driver's seat. A
message on the display/operating unit asks
the operator to place the FleetManager card
in position or to enter the PIN code.
Authorisation via the "FleetManager" card
or the PIN code must take place within a
specified period of time:
• Within 30 seconds if the driver's seat is not
occupied
• Within 60 seconds if the driver's seat is
occupied
If this does not happen, the truck switches off
again.
– To switch on the truck, press the push
button (1) or sit in the driver's seat.
If authorisation was successful, the truck is
ready for operation. The main view is shown
on the display.
– To switch off the truck, press the push
button (1) and hold for 1 second.
118 56368011531 EN - 06/2019 - 02
Operation