Safety Regulations For Maintenance; General Information - Still RX20 Series Original Instructions Manual

5

Safety regulations for maintenance

Safety regulations for maintenance

General information

DANGER
Risk of explosion!
Working on a truck within potentially
explosive areas can lead to explosions
in the surrounding atmosphere.
No work must be performed on the
truck in potentially explosive areas!
– Trucks must only be maintained
and repaired outside potentially
explosive areas.
– Ask the safety officer to allocate a
safe working area.
All necessary safety measures must be taken
to prevent accidents during maintenance and
repair work:
– Apply the parking brake.
– Switch off the truck. Remove the switch key
or block access.
– Actuate the battery isolating switch (de-
pending on version) and the emergency
stop switch.
– Disconnect the battery male connector.
Category-2 versions of the truck have two
battery male connectors (+ and -). These are
secured against accidental disconnection with
screws. To prevent loss of the screws, screw
the screws back in place after disconnecting
the battery male connector.
– Ensure that the truck cannot move uninten-
tionally or start up inadvertently.
– If necessary, have the truck jacked up by
the authorised service centre.
Components specifically for explosion protec-
tion are attached on the underside of the truck.
If these components are damaged, the truck
is no longer approved for use in potentially
explosive areas.
– Have the raised fork carriage or the ex-
tended lift mast secured against accidental
lowering by the authorised service centre.
356 56368011531 EN - 06/2019 - 02
Maintenance