Wheel Chock (Variant) - Still RX20 Series Original Instructions Manual

Operation
– Turn the battery isolation switch (1) anti-
clockwise up to the stop and into the "OFF"
position.
NOTE
Switch keys, FleetManager cards (variant),
FleetManager transponder chips (variant) and
the PIN code for access authorisation (variant)
must not be handed over to other persons
unless explicit instructions to this effect have
been given by the responsible fleet manager.

Wheel chock (variant)

The wheel chock (variant) is used to prevent
the truck from rolling away on a slope. It is
located on the right-hand mudguard.
– Pull the latch forward (1) and hold it in place.
– Grip the wheel chock by its handle (3).
Remove the wheel chock from the support
mounting via the guide (2).
– Push the wheel chock under a front axle
wheel on the side facing the descending
gradient.
– After use, reinsert the wheel chock in the
support mounting.
– Make sure that it is correctly seated in the
guide (2) and that the latch (1) is holding the
wheel chock in place.
3
2
56368011531 EN - 06/2019 - 02
4
Parking
1
6219_901-006
1
6219_003-145
161