Messages About The Truck - Still RX20 Series Original Instructions Manual

Operation
Shown on display
Enable sprint mode
Sprint mode blocked — bat-
tery
Sprint mode blocked — tempera-
ture
Dead man switch
Overload
Battery overtemperature
Working mode active
Access expired
Access denied
Access expires in < 1 month
Access expires in < 1 day
Access expires in < 1 week
Access expires in < 2 days
Access expires in < 3 days
.

Messages about the truck

If messages with a code appear on the
display-operating unit, the truck control unit
has detected a fault. The message with a
code is stored in the message list until the
cause of the message is corrected. The saved
messages can be called up from the "message
list".
Cause/action
If the battery is charged after locking sprint mode
or a normal temperature is reached, this message
appears. Sprint mode can be used again once the
truck has been restarted.
If the battery experiences under-voltage or too high a
temperature, this message appears. Sprint mode is
no longer available.
- Observe the previous message.
If the temperature at the drive units is too high, this
message appears. Sprint mode is no longer available.
- Observe the previous message.
If the truck is equipped with a foot switch, and a
truck function is called up when the foot switch is
not actuated, this message appears.
- Actuate the foot switch.
With the "overload protection" variant, this message
appears if an excessive load is picked up.
- Set down the load.
If the truck control unit detects an excessive battery
temperature, this message appears.
- Allow the truck to cool down.
This message is not displayed during normal opera-
tion.
- Contact the authorised service centre.
If the truck is equipped with this variant, this message
might appear.
- See the associated instructions.
56368011531 EN - 06/2019 - 02
4
Display messages
293