Lubrication; Removing And Installing Parts Of The Lubrication System - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
17 –

Lubrication

1 Removing and installing parts of the
lubrication system
Note
If the engine is damaged and there is a suspicion that this
♦
damage was caused due to a mixture of oil with fuel (engine
odour test), then it is essential to check whether the tandem
pump is sealed on the inside
If considerable quantities of metal swarf as well as abrasion is
♦
found in the engine oil when carrying out engine repairs, care‐
fully clean the oil galleries in order to avoid consequential
damage and additionally replace the engine oil cooler as well
as the oil filter element.
The oil level must not be above the Max. marking on the oil
♦
dipstick - risk of damage to catalytic converter!
Check the engine oil, amount of oil and oil specification ⇒ Main‐
tenance ; Booklet Octavia II .
1 - 15 Nm
2 - 15 Nm
3 - Bracket at top
❑ Wiring for Oil level and
oil temperature sender -
G266-
❑ pay attention to different
version
4 - Drive chain sprocket
❑ for oil pump
❑ Removing and installing
⇒ page 62
5 - Dipstick
❑ Oil level must not ex‐
ceed the max. marking
6 - Hopper
❑ Remove for extracting
oil
7 - Guide tube
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
8 - Oil spray jet
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
❑ for cooling pistons
❑ Pay attention to part
number (right-angle
bend)
9 - Pressure relief valve, 27 Nm
❑ opens at an overpres‐
sure of 0.25 to 0.32 MPa
(2.5 to 3.2 bar)
❑ replace without sealant
122
Rep. gr.17 - Lubrication
⇒ page 178 ,