Inspect The Semi-Automatic Toothed Belt Tensioning Pulley - Skoda Octavia Workshop Manual

13
------------ 13-12 -------------
Crank Assembly
Inspecting semi-automatic toothed
belt tensioning pulley
Fitting location:
K l Lock bracket -arrow- in the recesses at the
cylinder head.
Inspection procedure
- Set engine to TDC of piston of cylinder 1.
K - Apply pressure to the toothed belt with your
thumb. Needle -2- must deflect.
- Release pressure on toothed belt and rotate
crankshaft two revolutions in direction of ro-
tation of engine until the engine is set to TDC
of piston of cylinder 1. It is very important
that the last 45° (1/8 turn) are rotated with-
out any interruption.
- The tensioning pulley must move back again
into its initial position (notch -1- and needle
-2- again move together).
Note:
Use a mirror for inspecting.
OCTAVIA
Edition 01.02
S00.5127.53.20