Table of Contents
Advertisement
6100-Cu Multifunction Copper Tester Operation Manual
cursor and place it in the middle of the current
x-axis limits.
Zoom references the middle of the x/y axis and
not the cursor position. Press the arrow keys
as follows:
o
Right = x-axis zoom in.
o
Left = x-axis zoom out.
o
Up = y-axis zoom in.
o
Down = y-axis zoom out.
Pan - use left/right arrow keys to pan the x-axis
and the up/down arrow keys to pan the y-axis.
1:1 resets the x-axis and y-axis limits to full
scale.
Return To Test removes these function keys
and displays the previous ones.
Result Details Count
The Results Details read-only page displays the WB
Impulse Noise Count, Detection Level, and pass/fail
status.
Profile Details
The WB Impulse Noise Profile Details read-only page
displays the test thresholds and parameters along with
the Impulse Separation Time value.
92
11.7 NEXT
The NEXT test measures the Near End Crosstalk
(NEXT) between 2 pairs of cables. The test transmits a
signal on the T/A - R/B pair, and measures the received
crosstalk on T1/A1 - R1/B1 pair.
Spot
Spot is a continuous mode of operation measuring the
crosstalk for a specific frequency selected by you,
similar to the method used by the Send Tone test. The
Spot function displays and updates results in real time,
until you stop the test. The last valid results then
remain displayed.
Current Group is the current test group name,
for example Noise Tests.
Current Test displays the test being
measured. Here you can switch to another
Noise test from the given list. However, this
© 2020 Radiodetection Ltd
Advertisement
Table of Contents
