Xtalk Tdr - SPX RADIODETECTION 6100-Cu Operation Manual

Dual Trace View
Load Coil

13.2 xTalk TDR

The xTalk TDR test transmits on one pair and receives
on pair two allowing you to detect and isolate split pairs
which may be causing service disruptions. The test
adds a hookup diagram in the form of a Confirmation
window at start up, showing you how to connect your
cables for this test.
© 2020 Radiodetection Ltd
6100-Cu Multifunction Copper Tester Operation Manual
When FED is Enabled on the FED Setup page, both
the T-R/A-B and T1-R1/A1-B1 pairs will be terminated
at the FED. The hookup diagram uses graphic and
textual components.

Proceed button closes the hookup diagram
prompt and starts the test.

Cancel button closes the hookup diagram
prompt only.
The Continuous function displays the line trace and is
continuously on and ready to use. It displays and
updates results in real time, in either Portrait or
Landscape Mode, until you stop the test. The last valid
results then remain displayed.

Current Group displays the test being
measured.

Current Test allows you to select either Auto,
Manual, or xTalk TDR.
Note: The test has the same parameters as the Manual
TDR test and does not inherit Auto TDR settings
(Range, Gain, Pulse Width) when switching to
the test from the Current Test setup line.
123