Table of Contents
Advertisement
Current Group is the current test group name,
for example Frequency Tests.
Current Test displays the test being
measured. Here you can switch to another test
from the given list. However, this action will
terminate the ongoing measurement test.
Cable Parameters:
o
Cable Type displays the ID, Cable
Name and Fill, and allows you to select
an entry (with its associated
parameters) from the current Cable
Book, to use for testing. The selection
is not saved when leaving the test. The
current Cable Book entry is shown by
default.
o
Cable Fill read-only entry is the type of
material the cable is filled with:
Aircore, Jelly, Pulp, 5 PR, or 2 PR.
Setup in the Cable Book.
o
Velocity of Propagation read-only
entry is the velocity of propagation for
the cable. Setup in the Cable Book.
o
Cable Temperature allows you to
change the temperature of the cable
under test in either °F or °C.
Select Graph button changes to Graph
Selected when pressed and opens a new
selection of function keys which allow you to
maneuver the graph as follows:
o
Cursor - press the left/right arrow keys
to decrease/increase the values by
moving the cursor. Press and hold the
left/right arrow keys to accelerate the
cursor. Press
and place it in the middle of the current
x-axis limits.
© 2020 Radiodetection Ltd
to recall the cursor
6100-Cu Multifunction Copper Tester Operation Manual
o
Zoom references the middle of the x/y
axis and not the cursor position. Press
the arrow keys as follows:
Right = x-axis zoom in.
Left = x-axis zoom out.
Up = y-axis zoom in.
Down = y-axis zoom out.
o
Pan - use left/right arrow keys to pan the
x-axis and the up/down arrow keys to
pan the y-axis.
o
1:1 resets the x-axis and y-axis limits to
full scale.
o
Return To Test removes these function
keys and displays the Detection page.
Result displays the number of load coils in text
and graphical format.
Test Status displays the current state of
measurement or an error message.
To select the parameter values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
TDR
The Load Coils TDR function provides a shortcut to the
TDR test. A dialog box opens, warning that you are
about to leave the Load Coils test. TDR results
captured while running Load Coils will be available
upon loading TDR. Please go to
information on this test.
TDR
on page 117 for
111
Advertisement
Table of Contents
