SPX RADIODETECTION 6100-Cu Operation Manual page 83


Current Group is the current test group name,
for example Noise.

Current Test displays the test being
measured. Here you can switch to another test
from the given list. However, this action will
terminate the ongoing measurement test.

VF Noise Filter allows you to define the voice
frequency noise filter to be used, dependent on
ITU or ANSI Standard mode and the Noise
Filter set in Setup/Application Settings.

Termination Resistance is a read-only value
of 600 Ω.

Threshold Settings button opens a new page
that allows you to set the VF Noise threshold.

Result displays the pass/fail status and VF
Noise value.

Test Status displays the current state of
measurement or an error message.
Note: The selected VF Noise Filter shown in addition to
the current Level units selected in
Setup/Application Settings have an influence on
the measurement units displayed on this page.
To select the parameter values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press on a value to open a list box of
options.
4. Press to confirm the value.
© 2020 Radiodetection Ltd
6100-Cu Multifunction Copper Tester Operation Manual
VF Noise Threshold Settings
The Threshold Settings page allows you to set the VF
Noise Threshold values for the test.

Type is the threshold limit: either Maximum or
Minimum.

Enabled is a flag to use the current threshold:
either Yes or No.
To set threshold values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press to confirm the value.
83