Table of Contents
Advertisement
6100-Cu Multifunction Copper Tester Operation Manual
Return Loss Threshold Settings
The Return Loss Threshold Settings page allows you
to set the Loss Threshold for each pair. The threshold
is a programmable value you can use as an on-screen
indicator in each test when a measured value is too
high or too low.
Type is the threshold limit for each pair: either
Maximum or Minimum.
Enabled is a flag to use the Return Loss
threshold: either Yes or No. For example,
setting the threshold Enabled to No will disable
pass/fail threshold.
To set threshold values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
Single Frequency Result Details
The Results Details read-only page displays the
pass/fail status, Return Loss and Frequency (TX)
values.
108
Sweep
The Sweep test allows you to configure parameters
and provides a snapshot measurement of Return Loss
in a graphical format, and pass/fail status.
Current Group is the current test group name,
for example Frequency Tests.
Current Test displays the test being
measured. Here you can switch to another
Frequency test from the given list. However,
this action will terminate the ongoing
measurement test.
Bandwidth allows you to select the frequency
range for the test from a list of available
bandwidths: ISDN, HDSL, SHDSL, ADSL1/2,
or ADSL2+.
Termination Resistance lists a choice of
resistance values for the termination of the
signal.
© 2020 Radiodetection Ltd
Advertisement
Table of Contents
