Wi-Fi Test - SPX RADIODETECTION 6100-Cu Operation Manual

6100-Cu Multifunction Copper Tester Operation Manual

WAN Link Speed is a choice between Auto
(negotiated during the link establishment), 100
or 10 Mbit/s.

WAN Connect Mode is Full- or Half-Duplex,
when Link Speed is set to either 100 or 10
Mbit/s.

VLAN Support enables the unit to tag/untag
Ethernet frames.

VLAN ID is a virtual local area network
(VLANtag ranging from 0 through 4094. The
entry is available only when VLAN Support is
Enable.

Vendor ID is the name of the unit. This entry is
available only when Access Mode is DHCP.

Local Mac Address is the internal MAC
address of the unit: either 6100-Cu or User
Defined.

Mac Address is a specific MAC address, in a
hexadecimal format, if User Defined was
selected for the previous parameter. This entry
is available only when Access Mode is DHCP
or Static.

WAN Login Timeout is a numeric setup entry.
The following parameters are available only when
Access Mode is PPPoE.
o
Login Name/Password is your user ID
and password.
o
Obtain IP is either Dynamic where the
access concentrator or broadband
remote access server assigns a
temporary IP address to the unit, or
Static where you enter the IP address
of the unit.
The following parameters are available only when
Access Mode is Static.
o
IP Address is the address for the unit
that is actively connected to your
network or the internet at the time of
login.
o
Gateway is the IP address of the
default gateway.
o
Subnet Mask is the network address
used to identify if the IP address is
within the same wide area network.
o
DNS1 is the address of the primary
domain name server to be used by the
unit. If DNS is unavailable, enter
0.0.0.0.
o
DNS2 is the address of the secondary
domain name server to be used by the
unit. If DNS is unavailable, enter
0.0.0.0.
20

Restore Default button allows you to reset the
entries to their defaults.
To configure the setup options:
1. Press the up/down arrows to select the desired
parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press to confirm the value.

6.10 Wi-Fi Test

Selecting the Wi-Fi Test icon activates the Wi-Fi Scan
function, listing all the Wi-Fi (wireless) networks
available to you.
Wi-Fi Scan
The Wi-Fi Scan tab displays all wireless networks
available with details that allow you to compare them.

Navigate to a Wi-Fi Network for Details
enables you to select a wireless network from
the list to view further details below.
o
Chan. displays the Wi-Fi channel
number.
o
Network Name or SSID (service set
IDentifier) is the name assigned to a
wireless network.
o
MAC Address or BSSID (basic service
set identifier) is the address of the WAP
(wireless access point).
o
RSSI is the received signal strength
indicator returned from the Wi-Fi dongle.

Sort Channels button allows you to toggle the
channel numbers by ascending and
descending.

Sort RSSI button allows you to toggle the RSSI
signal strength values by ascending and
descending.
Note: With touchscreen, you can also sort the network
names by clicking/tapping the column header.

Hide/Show Hidden Network button allow you
to hide/show hidden networks in the list.
© 2020 Radiodetection Ltd