Upload Setup - SPX RADIODETECTION 6100-Cu Operation Manual

6.9 Upload Setup

Upload Enable
The Upload Enable function allows you to upload your
test result files (FTP Result Upload option must be
enabled.)
The Out-band Upload Method allows you to use one
of the following methods:
Wi-Fi allows you to upload files from the 6100-Cu via a
Wi-Fi hotspot/router and is available for the following
results pages:

Copper User Auto Test from Upload/Save
Result tab

Copper User Auto Test from Result
Manager/Summary/Upload

All Copper results from Result
Manager/Upload
© 2020 Radiodetection Ltd
6100-Cu Multifunction Copper Tester Operation Manual
Note: Only channels 1 to 11 are supported on the Wi-Fi
hotspot/router.
A Wi-Fi symbol, in the top right-hand corner of
the navigation bar, identifies whether or not a
connection is present. The Wi-Fi status is
indicated as follows:
o
Green icon indicates that the 6100-Cu
is connected with a Wi-Fi hotspot.
o
Yellow icon indicates that the Wi-Fi
dongle is powered up and ok, but that
the 6100-Cu is not connected to any
Wi-Fi hotspot.
o
Red icon indicates a problem with the
Wi-Fi (dongle not attached, etc.).

Ethernet is the default upload and if selected,
displays an Ethernet
hand corner of the navigation bar. It identifies
whether or not a connection is present
displaying a green or yellow icon similar to the
Wi-Fi symbol described above.

Disable Upload option disables uploading your
files via Wi-Fi or Ethernet. You can export
results to a USB memory device.
The DSL In-band Upload method supports DSL or
Ethernet, and can be set to either Enable or Disable.
icon in the top right-
17