Preface; Before You Begin; Important Notices; Training - SPX RADIODETECTION 6100-Cu Operation Manual

Preface

1.1 Before you begin

Thank you for your interest in Radiodetection's 6100-
Cu Multifunction Phone Network Analyzer and Copper
Tester.
Please read this user manual in its entirety before
attempting to use the 6100-Cu system as it contains
many important safety notices and warnings.
Radiodetection products, including this manual, are
under continuous development. The information
contained within is accurate at the time of publication;
however, the 6100-Cu, this manual and all its contents
are subject to change.
Radiodetection Limited reserves the right to modify the
product without notice and some product changes may
have taken place after this user manual was published.
Contact your local Radiodetection dealer or visit
www.radiodetection.com
about the 6100 product family, including this manual.

1.2 Important notices

Read this manual in its entirety before attempting to
operate the 6100-Cu. Note all safety notices in the
preface and throughout this manual.
Ensure that you have read and understood the safety
notices in Section 4 Safety
WARNING: Failure to comply with safety warnings
can cause serious injury or death.
CAUTION: Failure to comply with safety cautions can
result in damage to equipment or property.
This equipment shall be used only by qualified and
trained personnel, and only after fully reading this
Operation Manual.
WARNING: Direct connection to live conductors is
POTENTIALLY LETHAL. Direct connections
to live conductors should be attempted by
fully qualified personnel only using the
relevant products that allow connections to
energized lines.
You are responsible for determining whether the
conditions are suitable for using this device. Always
carry out a risk assessment of the site to be inspected.
Follow your company and national safety procedures
and or requirements when operating this equipment in
any environment or workplace. If you are unsure what
© 2020 Radiodetection Ltd
for the latest information
Information.
6100-Cu Multifunction Copper Tester Operation Manual
policies or procedures apply, contact your company or
site's occupational health and safety officer or your
local government for more information.
Do not use this equipment if you suspect that any
component or accessory is damaged or faulty.
Use authorized accessories only. Incompatible
accessories may damage the equipment or give
inaccurate readings.
Keep this equipment clean and arrange for regular
services with an authorized Radiodetection service
center. More information can be found in the Appendix
or from your local Radiodetection representative.
Headphone use: you need to remain alert to traffic and
other hazards that are normally heard outdoors. Always
turn the volume down before plugging headphones into
an audio source and use only the minimum level,
necessary to take your measurements. Excessive
exposure to loud sounds can cause hearing damage.
Do not attempt to open or dismantle any part of this
equipment unless directed specifically by this manual.
Doing so may render the equipment faulty and may
void the manufacturer's warranty.
You are responsible for determining whether you
consider the measurement results to be valid and for
any conclusions that are reached or any measures that
are taken as a result thereof. Radiodetection can
neither guarantee the validity of any measuring results
nor can we accept liability for any such results. We are
on no account able to accept liability for any damage
which may be caused as a consequence of the use of
these results. Please see the Standard Warranty Terms
enclosed with the product for further information.

1.3 Training

Radiodetection provides training services for most
Radiodetection products. Our qualified instructors will
train equipment operators or other personnel at your
preferred location or at a Radiodetection location.
For more information go to
contact your local Radiodetection representative.
www.radiodetection.com or
5