SPX RADIODETECTION 6100-Cu Operation Manual page 144

6100-Cu Multifunction Copper Tester Operation Manual
TDR Result
The TDR Result page displays the TDR test result
cable parameters and the distance to the most
significant reflection or Largest Event, in text and
graphical format in either Portrait or Landscape Mode.
Δ
The distance (Delta) value between cursor and
marker is displayed on the top of the graph.

Current Test displays the test being
measured, for example Auto TDR.

Range allows you to set the range from the
given list.

Gain is a non-editable value that is updated
dependent on whether the Range was set to
Auto or a manual value.

Pulse Width is a non-editable value that is
updated dependent on the Range.

VOP allows you to change the velocity of
propagation value for the cable.

Cable Setup button allows you to view the
Cable Parameters of the TDR test.

Select Graph button changes to Graph
Selected when pressed and opens a new
selection of function keys which allow you to
maneuver the graph as follows:
o
Cursor/Marker allows you to select the
cursor (blue) or marker (red)
independently by toggling the function
key. The footer updates to reflect either
Move cursor or Move marker. Press
the left/right arrow keys to
decrease/increase the values by moving
the cursor/marker. Press and hold the
left/right arrow keys to accelerate the
cursor/marker. Press
144
TDR Result Cable Setup
The Cable Setup page allows you to configure and/or
view the Cable Parameters set for the TDR test.
to recall the
cursor/marker and place it in the middle
of the current x-axis limits
o
Zoom references the middle of the x/y
axis and not the cursor position. Press
the arrow keys as follows:
Right = x-axis zoom in.
Left = x-axis zoom out.
Up = y-axis zoom in.
Down = y-axis zoom out.
o
Pan - use left/right arrow keys to pan the
x-axis and the up/down arrow keys to
pan the y-axis.
o
1:1 resets the x-axis and y-axis limits to
full scale.
o
Return To Test removes these function
keys and displays the previous function
keys.

Landscape Mode button allows you to
configure and view the parameters and test
results in landscape mode. Whether the
keyboard is on the right or left is dependent on
your preferred Landscape Mode Settings
configured in Application Settings/General.

Cable Type displays the ID, Cable Name and
Fill, and allows you to select an entry (with its
associated parameters) from the current Cable
Book, to use for testing. The selection is not
saved when leaving the test. The current Cable
Book entry is shown by default.
© 2020 Radiodetection Ltd