Table of Contents
Advertisement
WB PSD Noise Threshold Settings
The Threshold Settings page allows you to set the
RMS Noise Threshold parameters for the test.
Type is the threshold limit for each pair: either
Maximum or Minimum.
Enabled is a flag to use the current threshold:
either Yes or No.
To set threshold values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
Select Masks
The Select Masks tab allows you to set parameters
and choose which Masks to enable for the PSD test.
© 2020 Radiodetection Ltd
6100-Cu Multifunction Copper Tester Operation Manual
Select Files is either None which removes all
check marks allowing you to select one or
more Masks, or All.
DPBO (Downstream Power Back Off) is either
ON or OFF.
ESEL (Exchange Side Electrical Length) is
used to enter or modify the numerical values of
attenuation of the cable at 1 MHz frequency
from 0 to 120 dB with one decimal point. This
represents the DPBOESEL variable or
electrical length of exchange to cabinet cable,
and is applied to the DPBO mask calculation.
Note: DPBO and ESEL are only available if
Termination is set to Bridging or Hi-Z Cable.
Masks lists all the networks available to select
dependent on the ITU or ANSI Standard mode
set in Setup/Application Settings/Standard.
To set parameters and enable the Masks for the
PSD test:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
5. If None is selected for the files, press the down
arrow key to highlight the list box of Masks and
press
to open the list.
6. In the list, press the up/down arrows to
highlight the desired files and press
select/deselect a Mask.
to
89
Advertisement
Table of Contents
