Table of Contents
Advertisement
6100-Cu Multifunction Copper Tester Operation Manual
Cancel button removes the
confirmation/warning message without
impacting the cable book.
To load a cable book:
1. Select the Storage Location using the
left/right arrow keys.
OR
2. Press
to display the list of options.
3. Using the up/down arrow keys, select a file
name to load.
4. Press Load and confirm. The unit will remove
the existing cable book and replace it with the
loaded one.
OR
5. Press Cancel to remove the message.
Save Cable Book
The Save Cable Book page allows you to save or
export a cable book.
Save File allows you to enter a file name of the
current cable book to save. By default, the
name is cable_book.csv.
The Storage Location lists the save
destinations:
o
Internal memory
o
USB
Save button saves the selected file.
38
Note: The unit will overwrite any document with the
same file name found on the disk, without
warning.
To save a cable book:
1. Accept the default file name or press
create a new one using the edit screen.
2. Select a Storage Location.
3. Press Save.
7.7 Application Settings
Before executing the copper tests, set up the software
settings and values for the cables. The 6100-Cu allows
you to save standard parameter settings to different
profiles and reuse them as needed.
To access Application Settings:
From the Home pane, select Copper Test, then
Setup, and Application Settings.
General
The General tab allows you to configure the unit with
specific measurement values and graph viewing
settings.
Each parameter is described below:
Cable Temperature specifies the temperature
of the cable under test in either ⁰F (Fahrenheit)
or ⁰C (Celsius) units.
Capacitance Measurement is either 3
Terminal or 2 Terminal. The latter method
measures the capacitance across the 2
terminals specified (either T-R, T-G, R-G or A-
B, A-E, B-E), whereas the 3 Terminal method
to
© 2020 Radiodetection Ltd
Advertisement
Table of Contents
