SPX RADIODETECTION 6100-Cu Operation Manual page 120

6100-Cu Multifunction Copper Tester Operation Manual
o
Return To Test removes these function
keys and displays the previous ones.

Result displays the distance to the most
significant reflection, in text and graphical
measurements. The distance
between cursor and marker is also displayed at
the top of the graph.

Test Status displays the current state of
measurement or an error message.

Load Trace function key opens a new page
that allows you to load a trace from a list of
previously saved TDR tests.

Clear Trace function key deletes the loaded
trace from the graph.
To select the parameter values in Portrait Mode:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view, select
the options, or increase/decrease values.
OR
3. Press on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press to confirm the value.
Landscape Mode is the best way to use the TDR and
allows you to view the test results in landscape mode
utilizing the full length of the high resolution, color
screen. Whether the keyboard is on the right or left is
dependent on your preferred Landscape Mode
Settings configured in Setup/Application
Settings/General.
Landscape Mode generates the following
function keys:
120
Δ
(Delta) value
To select the parameter values in Landscape Mode:
o
Portrait Mode is used to change the
screen orientation from landscape to
portrait.
o
Select Graph opens a new selection of
function keys which allow you to
maneuver the graph. (Same as above.)
o
Parameters displays a small strip
window listing the following values:
Range, Gain, Pulse Width, and Current
Trace (not in Auto TDR). They can be
edited or viewed the same way as in
Portrait Mode (described above),
dependent on the TDR test being run.
o
Cable Setup displays a small strip
window when selected allowing you to
change the Cable Type, Velocity of
Propagation, and Cable Temperature.
You can also view the Cable Fill entry
which was setup in Cable Book. For
more information, see Cable Setup in
portrait mode.
1. Press the desired function key.
2. For Parameters and Cable Setup, press the
up/down arrow keys to highlight the desired
parameter.
3. Press the left/right arrow keys to view, select
the options, or increase/decrease values.
4. Press to confirm the value.
© 2020 Radiodetection Ltd