Table of Contents
Advertisement
6100-Cu Multifunction Copper Tester Operation Manual
Voltage Thresholds
The AC/DC Voltage Threshold Settings page allows
you to set the Threshold Voltage for each pair. The
threshold is a programmable value you can use as an
on-screen indicator in each test when a measured
value is too high or too low.
Type is the threshold limit for each pair: either
Maximum or Minimum.
Enabled is a flag to use the voltage threshold:
either Yes or No.
To set threshold values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
Continuous AC Page
The Continuous AC function measures each pair,
displaying and updating results in real time, until you
stop the test. The last valid results then remain
displayed. The Voltage test defaults to the Continuous
DC page from the Multimeter menu.
Continuous AC and Continuous DC are run
synchronously. Press Start/Stop on the keypad to run
the test.
56
Current Group is the current test group name,
for example Multimeter.
Current Test displays the test being
measured. Here you can switch to another test
from the given list. However, this action will
terminate the ongoing measurement test.
Selected Pair allows you to select All Pairs or
a single wire pair for measurement.
Termination Resistance defines how much
resistance the tester uses to connect to the line
and measure voltages.
Threshold Settings button opens a new page
that allows you to set the AC voltage
thresholds for each pair.
Result displays a snapshot of the pass/fail
status, volts and frequency (Hz) values for
each continuous AC pair.
Test Status displays the current state of
measurement or an error message.
To select the parameter values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options.
4. Press
to confirm the value.
© 2020 Radiodetection Ltd
Advertisement
Table of Contents
