Table of Contents
Advertisement
6100-Cu Multifunction Copper Tester Operation Manual
Auto Tests
15.1 Menu
Auto Test allows you to automatically run tests used in
pre-qualification, installation, and maintenance of
different circuit types from POTS to VDSL2. The main
menu allows you to select and run the displayed tests:
POTS Auto Test detects the loop current and
measures voice frequency parameters in a
copper telephone loop.
User Auto Test runs a range of different user-
defined tests.
To activate a test:
1. Press the left/right arrow keys on the keypad to
select the desired test icon.
2. Press
to confirm your selection.
3. The test will start automatically if the
Setup/Application Settings - Test Startup
Mode is set to Auto. If not, press Start/Stop on
the keypad.
15.2 POTS Auto Test
The purpose of the POTS Auto Test is to detect the
loop current and measure the voice frequency
parameters in a copper telephone loop. This test allows
you to compare measured results against stored
threshold values to provide pass or fail status results of
the POTS circuit type.
136
Copper
To access POTS Auto Test:
1. From the Copper Main menu, use the
up/down, left/right arrow keys to highlight Auto
Test and press
2. Highlight POTS Auto Test and press
start the test.
Summary
The Summary page displays detailed results of the
loop current, Power Influence and voice frequency
measurement values, pass/fail status, and parameters.
POTS Auto Test consists of a combination of multiple
tests.
Current Group is the current test group name,
for example Auto Test.
Current Test displays the test being
measured. Here you can switch to another test
from the given list. However, this action will
terminate the ongoing measurement test.
VF Noise Filter displays the voice frequency
noise filter used, dependent on ITU or ANSI
Standard mode and the Noise Filter set in
Setup/Application Settings.
.
to
© 2020 Radiodetection Ltd
Advertisement
Table of Contents
