Wb Psd Noise - SPX RADIODETECTION 6100-Cu Operation Manual

3. Press on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press to confirm the value.
Result Details
The Results Details read-only page displays the High,
Mid, Low VF Impulse Noise Count and Detection
Level values, and the pass/fail status of the Mid level.

11.5 WB PSD Noise

The wideband power spectral density (PSD) noise test
measures the noise energy at a point in a noise
spectrum. It is expressed as power per hertz at a point
in a noise spectrum.
PSD
The PSD page allows you to configure the parameters
for the wideband PSD noise test and view the results
in either Portrait or Landscape Mode.
© 2020 Radiodetection Ltd
6100-Cu Multifunction Copper Tester Operation Manual

Current Group is the current test group name,
for example Noise Tests.

Current Test displays the test being
measured. Here you can switch to another test
from the given list. However, this action will
terminate the ongoing measurement test.

Bandwidth allows you to select the frequency
range for the test from a list of available
bandwidths: ISDN, HDSL, SHDSL, ADSL1/2,
ADSL2+, VDSL2-8, VDSL2-12, VDSL2-17,
VDSL2-30, or VDSL2-35.

Noise Filter defines the filter currently enabled.
Options are: None, ISDN-E, HDSL-F, ADSL-G,
ADSL, ADSL2+, VDSL, VDSL2-8, VDSL2-12,
VDSL2-17, VDSL2-30, VDSL2-35.

Termination is one of the following:
o
Terminated if the termination
resistance is internal to the unit.
o
Bridging if additional termination
resistance is used to bridge onto live
circuits with minimal interruption.
o
HiZ Cable when using this cable to
connect to T1/A1-R1/B1 (Yellow –
Blue) connectors. When selected, the
Termination Resistance automatically
sets to 100 Ω.

Termination Resistance allows you to select
the resistance of the dummy load connected to
the line, unless HiZ Cable is selected above.

Mask allows you to select a network
representing the power signal of other services,
overlaid on the active noise graph, to identify
its presence on the line under test. All of the
masks you enabled from the Select Masks tab
are listed here for test selection.
87