6100-Cu Multifunction Copper Tester Operation Manual
The purpose of the noise tests is to perform VF/WB
(voice frequency / wideband) noise and level
measurements.
Note: The 30 MHz Wideband Testing software option is
required for the WB tests to be available.
To access noise tests:
From the Copper Main pane, highlight Noise Tests
and press
to open the menu.
82
Noise Tests
11.1 Noise Tests Main Page
The Noise Tests menu allows you to select and run
the displayed tests:
VF Noise
Power Influence
VF Impulse Noise
WB PSD Noise
WB Impulse Noise
NEXT
To start/stop a test:
1. Press the up/down left/right arrow keys on the
keypad to select the desired test icon.
2. Press
to confirm your selection.
3. The test will start automatically if the
Setup/Application Settings - Test Startup
Mode is set to Auto. If not, press Start/Stop on
the keypad.
11.2 VF Noise
The VF Noise test allows you to measure the amount
of unwanted or disturbing energy introduced into a loop
from man-made and natural sources.
Detection
The Detection function displays and updates results in
real time, until you stop the test. The last valid results
then remain displayed.
© 2020 Radiodetection Ltd