Table of Contents
Advertisement
6100-Cu Multifunction Copper Tester Operation Manual
Termination Resistance defines how much
resistance the tester uses to connect to the
line, and is set as follows:
o
for VF Receive Tone, a read-only
value of 600 Ω.
o
for WB Receive Tone, select 100, 120,
or 135 Ω.
FED Frequency Group allows you to select
the frequency that the TS125 FED will transmit,
from a preset list.
o
for VF Receive Tone:
POTS/PSTN: 404, 804, 1004, 1204,
1804, 2204, 2404, 2804, 3204, 3404 Hz
VF 5 Tone: 404, 1004, 2804, 3004, 3604
Hz
o
for WB Receive Tone:
HDSL: 20, 30, 50, 70, 90, 110, 130, 196,
400 kHz
T1/E1: 200, 400, 500, 700, 772, 1024
kHz
ADSL1/2+: 25, 69, 90, 110, 138, 300,
550, 800, 1104, 2208 kHz
VDSL2-12: 25, 138, 276, 3000, 3750,
5200, 8500, 12000 kHz
WB 5 Tone: 196, 392, 772, 1100, 2200
kHz
Select Graph button changes to Graph
Selected when pressed and opens a new
selection of function keys which allow you to
maneuver the graph as follows:
o
Cursor - press the left/right arrow keys
to decrease/increase the values by
moving the cursor. Press and hold the
left/right arrow keys to accelerate the
cursor. Press
place it in the middle of the current x-axis
limits.
o
Zoom references the middle of the x/y
axis and not the cursor position. Press
the arrow keys as follows:
Right = x-axis zoom in.
Left = x-axis zoom out.
Up = y-axis zoom in.
Down = y-axis zoom out.
o
Pan - use left/right arrow keys to pan the
x-axis and the up/down arrow keys to
pan the y-axis.
o
1:1 resets the x-axis and y-axis limits to
full scale.
116
to recall the cursor and
o
Return To Test removes these function
keys and displays the test page.
Result displays the values for both the RX
VF/WB Loss and Frequency.
Test Status displays the current state of
measurement or an error message.
To select the parameter values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options and use the navigation keys to scroll
through.
4. Press
to confirm the value.
Multiple Tone Graph Result Details
The Result Details read-only page displays the RX
VF/WB Loss and Frequency results in graphical format
for the Multiple RX Tone with FED test.
Test Group is the overall test group of the
selected saved results file, for example
Frequency Tests.
Test Identification is the test type of the
group, for example RX Tone with FED.
Test Modes is the mode of test, for example
Multiple Tone.
Select Graph button changes to Graph
Selected when pressed and opens a new
© 2020 Radiodetection Ltd
Advertisement
Table of Contents
