Figure 34: Installing the cable clamp
▶ Push the cable clamp into the corresponding hole until it clicks in.
Concluding steps
▶
"Connecting the power cord" on page
▶
"Performing a fan test" on page
6.4.2
Removing a hot-plug PSU
Customer Replaceable
Unit (CRU)
Tools:
tool-less
Note for removing a hot-plug PSU from a redundant configuration
If a hot-plug PSU should be removed from a redundant configuration, while the
system is in operation, proceed the following:
RX1330 M5
57.
94.
Upgrade and Maintenance Manual
Power supply unit (PSU)
Hardware: 5 minutes
103