Spoked Wheel Offset Adjustment; Wheel Truing - Victory Cross Roads Classic Service Manual

Table of Contents

TIRES / WHEELS

Spoked Wheel Offset Adjustment

1. Lay a straight edge on the brake disc mounting

surface and measure the offset distance to outermost

edge of rim (A).

2. If the offset measurement is too large, loosen spokes

on the opposite side of the rim and tighten spokes on

the measurement side to decrease the wheel offset.

Reverse this process to increase wheel offset.

3. Initially tighten spokes in 3 steps to the specified torque

while maintaining distance A. This is a starting torque

only. Final torque is listed on page 4.14

Initial Spoke Torque: 69 in-lbs (8 Nm)

4. Place straight edge on disc mounting surface and

measure to edge of rim. Verify that wheel offset is

correct after tightening spokes.

NOTE: All spokes must be loosened or tightened the

same amount to maintain minimum axial and radial

1. Inspect wheel offset as outlined on page 4.12 before

truing the wheel

2. Measure axial and radial runout.

9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

NOTE: Axial runout is side to side movement

(wobble) of the rim. Radial runout is the up and down

movement (hop) of the rim.

Table of Contents