Troubleshooting - Victory Cross Roads Classic Service Manual

FUEL SYSTEM / FUEL INJECTION

TROUBLESHOOTING

Fuel System Troubleshooting
PROBLEM
Engine turns over with
electric starter, but won't
start
Poor Idle / High Idle
Poor Running in Higher
RPM Range
5.58
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
POSSIBLE CAUSE
Compression too low
No spark at spark plugs
No fuel reaching intake
tract
Excessively rich or lean
fuel mixture
Spark at wrong time or
no spark. Fuel delivery
timing incorrect.
Excessively rich or lean
fuel mixture
Air intake restriction
Oil Overfilled
Ignition problems
Low Battery Voltage
Loose, corroded, or wet
connector(s)
Valve train problems
© Copyright 2012 Polaris Sales Inc.
AFFECTED PART(s)
See engine section
See ignition system
Out of fuel
Blown Fuse
Plugged fuel filters / lines
Fuel pump not working
Fuel pressure regulator
Faulty fuel pump relay
Open wiring / connector
Faulty connection at ECM
Fuel pump
Fuel pressure regulator
Crank Position Sensor
Low Battery
TMAP sensor
CHT sensor
Fuel Injector
Timing Wheel or CPS
installed incorrectly,
damaged, or dirty; faulty
CPS
Low Battery Voltage
Air Leaks
Air restriction in IAC
Fuel Pump
Fuel injector or fuel rail
obstructed or leaking
Air Filter
Wrong Fuel / Old Fuel
Crank Position Sensor
Throttle Plates
Air filter
-
Ignition Coil(s) / plug wires
Battery
ECM and wiring harness
Valve springs, valve, head
REPAIR RECOMMENDED
Add Fuel
Replace
Clean/Replace
Test / Replace
Test / Replace
Test / Replace
Inspect / Repair
Inspect / Repair
Test / Replace
Test / Replace
Test / Replace
Test / Replace
Test / Replace
Test / Replace
Test / Replace
Install correctly, inspect for
proper air gap (gap is preset
but cover, sensor, and timing
wheel must be clean and in
good condition).
Inspect Battery & Charging
Inspect IAC system
Inspect IAC hoses and fittings
Inspect fuel pressure
Replace
Replace
Inspect / Replace
Inspect / Replace
Remove carbon residue
Inspect
Inspect oil level and condition
Refer to ignition section.
Charge or replace
Unplug connections - inspect
Inspect cylinder head & valves