Oil Pump Inspection - Victory Cross Roads Classic Service Manual

Table of Contents

LUBRICATION & COOLING

Oil Pump Inspection

Inspect the oil pump when lubrication oil pressure is below

specification. The oil pump contains (2) sets of gerotors.

Follow the inspection procedure for both sets of gerotors

and both ends of the pump.

Keep gerotors together as a set, and oriented the same

way (dots on each gerotor must be on the same side upon

assembly). The parts are not interchangeable.

If dots on the gerotors are not visible, mark the gerotors

upon disassembly so they can be matched and oriented

properly upon assembly.

Before disassembling pump completely, follow these

inspection steps, and compare to specifications on

1. Remove the pump base (A) and lubrication side end

2. Measure tip clearance as shown below for both cooling

(larger gerotor set) and lubrication.

9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

3. Measure clearance between pump body and outer

gerotor on the lubrication side.

4. Measure clearance between pump body and outer

gerotor on the cooling side.

5. Measure the oil pump end clearance with a feeler

gauge at point (C). Lubrication side of pump is shown

below. Cooling side is measured in the same manner.

Table of Contents