Left Crankcase Assembly - Victory Cross Roads Classic Service Manual

TRANSMISSION & CRANKSHAFT

Left Crankcase Assembly

Prepare LEFT crankcase for assembly:
Refer to exploded view on page 10.4 for torque values,
bearing press depth, and locking agent.
1. Clean crankcase and oil passage (A) thoroughly.
Rinse and dry with compressed air.
A
• Install new bearings in crankcase as required
• Apply a film of lithium grease to outer race of
bearings to prevent galling upon installation
• Press on outer race of bearings using an arbor
press and a suitable arbor that is slightly smaller
than bearing outside diameter
• DO NOT press on inner race of ball bearings
10.22
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
2. Press balance shaft bearing from the primary side
using an arbor press (B).
CLUTCH SHAFT INSTALLATION
3. Place clutch shaft support tool press plate on clutch
side of crankcase to support inner race of bearing.
Clutch shaft is a firm press-fit in bearing, and bearing
damage may result if inner race is not supported during
the press operation.
Special tool:
Clutch Shaft Bearing Support: PV-47331
4. Press clutch shaft until fully seated using an arbor
press (C). Check for smooth, quiet operation after shaft
is installed.
© Copyright 2012 Polaris Sales Inc.
B
C