Transmission Removal - Victory Cross Roads Classic Service Manual

4. When 6th gear is fully installed, abruptly rock the
mainshaft so the bearings move into the mainshaft
pockets or use a small dowel to push the ball bearings
into the mainshaft pockets. Check for proper NSA
operation by trying to remove the 6th gear from the
main shaft; the gear should not pull up and off of the
mainshaft without performing steps 1-4 of the removal
process.
5. If NSA operation is correct, reassemble mainshaft as
outlined in this chapter.
CAUTION
Only use Victory engine oil to lubricate transmission
components. Using grease or other lubricants may
cause incorrect operation of the NSA system.

Transmission Removal

1. If not removed previously, remove countershaft
locating nut and washer (A). Use clutch shaft holder
PV-45028 to prevent shaft rotation.
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
Use small dowel
and push balls in,
if necessary.
A
© Copyright 2012 Polaris Sales Inc.
TRANSMISSION & CRANKSHAFT
2. Remove shift drum star (B).
B
3. Remove shift fork shafts (C).
4. Disengage shift forks from grooves in the shift drum.
5. Remove shift forks, shift drum, mainshaft and
countershaft from crankcase.
6. Carefully lift crankshaft out of left case.
C
10.13
10