Victory Cross Roads Classic Service Manual page 498

Stator Removal
1. Remove primary cover (page 9.9).
2. Place primary cover on bench with padded material
between primary cover and bench top.
3. Remove wiring retainer plate (A).
4. Remove three (3) socket head screws (B).
5. Remove stator from primary cover.
A
B
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
BATTERY CHARGING SYSTEM
Stator Installation
1. Clean stator mounting surface and screw holes in
primary cover.
2. Place stator in primary cover taking care to route wires
correctly in the channel.
3. Install screws and torque 100 in-lbs(12 Nm ).
4. Install grommet (C) into groove in cover and then install
retainer plate. Torque screws to 50 in-lbs (5.7 Nm).
5. Pull wires to remove any slack or loop at point (D).
Wires must not protrude into flywheel rotor area.
6. Install primary cover (page 9.12).
Flywheel Removal
Refer to page 9.24.
© Copyright 2012 Polaris Sales Inc.
C
PULL
D
16.17
16